|Hadi Industrial Area, Nancheng District, Dongguan, Guangdong, Chinafirstname.lastname@example.org|
|Product Name:||Precision Laminating Machine||Max Rewinding Diameter:||400mm|
|Max Winding Diameter:||500mm||Sticking Speed:||50m/min|
|Power Supply：:||220V 50HZ||Maximum Feeding Width:||210mm|
|Total Power:||0.85KW||Laminating Precision:||±0.1mm|
High Precision Aluminium Foil Laminating Machine
Description of operating panel
1 Magnet powder controller: Adjust tension of feeding unit and winding unit.
2. Adjuster for winding motor: Adjust winding speed of winding unit.
3. Adjustment of laminating speed: Adjust lamination speed .
4. Start button: Operate main motor.
5. Stop button: Stop main motor.
6. Inching button: Inch motor.
7. Power switch: Power on/off.
8. Emergency stop button: Cut off power of main motor.
This machine is a multifunctional laminating waste discharging machine, multilayer material jointing waste, can be applied to the mobile phone, computer, liquid crystal displays and other electronic label industry adhesive tape adhesive composite equipment products. Reeling waste magnetic powder tension control is adopted. A composite single, double-sided adhesive with bottom paper function. At the same time can be more complex and has a local joint function.
North America,South America,Western Europe,Eastern Europe,Eastern As,North America,North America, South America ,Western Europe,Eastern Europe,Eastern Asia,Southeast Asia,Middle East
Notes for attention
1. Please use voltage of 220V/380v properly. Tolerance of input voltage shall be ＋/-20V and the machine shall be grounded properly to prevent from injury as a result of electricity leakage.
2. Be sure to turn off the power and take off the plug before the machine is adjusted to ensure safety. Keep children and people other than operators away to prevent from any danger.
3. There shall not be any water being injected out when an air gun is used to clean dust in the electrical box. In this case, please discharge water out of the air compressor.
4. Placement of the machine: Wall surface of rear rack of the machine shall be over 500mm away from the wall, and there shall be a maintenance space reserved at two sides.
Main Technical Parameters
|Max Feeding Width||210||300||350|
|Max Rewinding Diameter||400mm||400mm||400mm|
|Max Winding Diameter||500mm||500mm||500mm|
|Main Engineer Power||0.4KW||0.4KW||0.75KW|
|Power Supply||220V 50HZ||220V 50HZ||220V 50HZ|